![]() |
|
|
|
|
|
Navigation
News
|
|
Statutory Instrument 1999 No. 1025The Highways (Road Humps) Regulations 1999(The document as of February, 2008) STATUTORY INSTRUMENTS1999 No. 1025The Highways (Road Humps) Regulations 1999
The Secretary of State for the Environment, Transport and the Regions, as respects England, and the Secretary of State for Wales, as respects Wales, make these Regulations in exercise of powers conferred by sections 90C(1) and 90D(1) and (2) of the Highways Act 1980[1], and of all other powers enabling them in that behalf, and after consultation with representative organisations in accordance with sections 90C(6) and 90D(3) of that Act- Citation and commencement 1.These Regulations may be cited as the Highways (Road Humps) Regulations 1999 and shall come into force on 28th April 1999. Interpretation 2. - (1) In these Regulations-
(b) a traffic sign of the size, colour and type shown in diagram 674 of the Traffic Signs Regulations 1994 is placed at each entrance to the zone for vehicular traffic; and
(2) A reference in these Regulations to a traffic sign is a reference to that sign, if used in Wales, with the prefix W as prescribed by the Traffic Signs (Welsh and English Language Provisions) Regulations 1985[5].
(b) in all cases, the chief officer of the fire brigade for the area in which the highway concerned is situated and the chief officer of any body providing ambulance services under the National Health Service Act 1977[6] and operating in that area; (c) in all cases, organisations appearing to him or them to represent persons who use the highway to which the proposal related, or to represent persons who are otherwise likely to be affected by the road hump. Nature, dimensions and location of road humps
(b) it has a minimum length of 900 millimetres measured parallel to an imaginary line along the centre of that carriageway from the point where one face meets the surface of that carriageway to the point where the other face meets the surface of that carriageway; (c) the highest point on it is not less than 25 millimetres nor more than 100 millimetres higher than an imaginary line parallel to the centre line of that carriageway connecting the surface of that carriageway on one side of the road hump to the surface of that carriageway on the other side of the road hump and passing vertically below that point; and, (d) no vertical face of any material forming part of that road hump exceeds 6 millimetres measured vertically from top to bottom of that face. (2) A road hump may be constructed and maintained in a highway so that an imaginary line along the centre of the hump from one side of the road to the other is in the same position as an imaginary line from one side of the road to the other along the centre of the pattern of black and white stripes specified in paragraph 8(1) of Part II of Schedule 1 to the Zebra, Pelican and Puffin Pedestrian Crossings Regulations and General Directions 1997[7].
(b) within 2 metres of any rail providing support and guidance for vehicles carried on flanged wheels and running in a carriageway of that highway otherwise than at a railway level crossing; (c) under or within 25 metres of any part of a structure over a carriageway of that highway any part of which is 6.5 metres or less above the surface of the carriageway; or, (d) above or within 25 metres of any part of a bridge over which a carriageway of that highway passes or any part of a tunnel, culvert or other similar structure which crosses beneath a carriageway of that highway. Lighting of road humps
(b) a system of street lighting complying with the British Standard for Road Lighting published by the British Standards Institution under number BS 5489 or with an equivalent standard or code of practice published by a national standards body or equivalent body of any EEA State before 28th April 1999; or, (c) lighting specially provided for the road hump. Placing of traffic signs (This note is not part of the Regulations) These Regulations revoke the Highways (Road Humps) Regulations 1996 and replace them with new provisions. The principal changes are:
(b) The signing and lighting provisions and certain provisions relating to the placing of road humps do not apply to a road hump in a 20mph zone. British Standard 5489 may be obtained from any outlet operated by the British Standards Institution (BSI) or by post from BSI at 389 Chiswick High Road, London W4 4AL (Telephone number: 0181-996-9000). Notes: [1] 1980 c. 66; sections 90A to F were added by the Transport Act 1981 (c. 56), Schedule 10.back [2] 1984 c. 27.back [3] Part I of S.I. 1994/1519, to which there are amendments not relevant to these Regulations.back [4] Cm 2073 and 2183.back [5] Part I of S.I. 1985/713.back [6] 1977 c. 49.back [7] S.I. 1997/2400.back [8] S.I. 1996/1483.back ISBN 0 11 082508 X -- Back --
Stat
|
Other
|